Question, I looked at the truck "Bad Influence" and noticed he had a K&N intake on that truck. I have the same exact model and engine, but haven't been able to find a kit due to some vacuum hoses leading to the air intake. Does anyone know how that intake was done for that truck?

Thanks,
 Yason06  

check ur local autoparts store like autozone, o'reillys, or sdvanced they should have one ur looking for. if not then try looking at a diff model of cehicle wit the same specs it should fit.  

I built this intake for 40 bucks from an acura integra using stock parts. Cut the MAF in half to mount to the filter. To mount the IAT, just trim the hole to mount the plastic threaded plug with the plastic nut on the inside (mount close enough to the intake to fit hand in)The vacuum lines are already on the intake. Easy 30 minute install and you can notice the difference.